You only see cabling when it goes wrong. Done right, it disappears for 15+ years and absorbs every upgrade you throw at it. Done badly, you're paying for it again every two years.
Challenges we solve
Cables that nobody can trace — A failed switch port turns into a half-day hunt because nothing is labelled, nothing is documented, and the previous installer left.
Network speed capped by old copper — Cat-5e installed a decade ago throttles modern Wi-Fi 6E and PoE++ — you bought new gear, but inherited yesterday’s bottleneck.
Recurring rework every refit — Every renovation rewires from scratch because the original was thrown together; capex stacks up year after year.
How we approach it
Cat-6A copper backbone — 10GBASE-T to every desk, certified to TIA-568 — ready for Wi-Fi 7, PoE++, and IP cameras on a single architecture.
OM4 / OS2 fibre risers — 100G-ready vertical backbone using MPO trunks, splice boxes, and properly grounded enclosures.
Patch panel & labelling discipline — Every drop labelled at both ends, every patch panel mapped, every change logged — your IT team finds the right cable in 30 seconds.
IP telephony & SIP — Voice rides the same backbone with QoS — sales floors stop sounding like wind tunnels.
Cable tray & containment — Built to code, designed for the next contractor — additions and changes do not require a forklift upgrade.
Full TIA-568 certification — Every link tested with calibrated equipment; pass/fail reports archived for the lifetime of the install.
Key features
15-year design horizon — We engineer for the gear arriving in 2030, not the gear shipping today.
Salt-air & industrial ratings — Specialist cable for piers, plant floors, and outdoor installs that must survive years of abuse.
Fibre splice & termination — Carrier-grade splice work, OTDR-tested, documented to the exact splice loss per joint.
Frequently asked questions
Should we install Cat-6A or Cat-6?
Cat-6A is now the practical floor for new installs — full 10G to 100m, properly handles PoE++ heat. Cat-6 is acceptable only on tight refurbishments where 1G is the ceiling.
Do we need fibre or just copper?
Fibre belongs between floors and to the server room. Copper handles the last 100m to the user. Most builds are both.
Can you re-cable while we operate?
Yes — we plan cutovers around your operating hours, or run the new cable in parallel and migrate port-by-port.
Serving businesses across Hong Kong and Macau. Book a site survey or speak to our team about your IT infrastructure, network, security, or AI workflow project.